Sirius Satellite Radio S-DDH1 Use And Maintenance Instruction page 78

F: Timer
10 min after setting, it serves to stop the ex-
tractor motor, close the carriage and switch
the lights off, if they are on.
The set function is signalled by the flashing
LEDs "D" for the set speed.
The timer can be cancelled by pressing the
key again.
TIMING
Other functions:
As a result of the new EU65 "Energy label"
and EU66 " Ecodesign" regulations issued
Automatic turn off:
by the European Commission, which came
After 4 hours of continuous working from the
into force as from January 1st, 2015 , our
last setup, the appliance turns off and closes
products have been adapted to comply with
automatically.
these new requi-rements. All of the models
complying with the energy label require-
Grease filters saturation:
ments, are equipped with new electroni-cs
After 30 hours of working, the speed indica-
including a timer device for suction spe-
tors "D" will all flash simultaneously, signaling
eds control, when the air capacity exceeds
the grease filters saturation.
650m³/h. Internal motor models, with maxi-
To reset this alarm, hold down the "TIMER"
mum air capa-city higher than 650m³/h, are
button for at least 3 seconds, while the car-
equipped with a ti-mer device that automati-
riage is open.
cally switches the suc-tion speed from 4th to
3rd speed, after 6 minutes operation. Exter-
Calibration:
nal motor models are equipped with remo-te
The cooker-hood carries out its self-calibra-
motors that , as for internal motor versions,
tion every 3 complete cycles of its extractable
include a timer device that switches down
unit.
the suction speed when it exceeds 650 m³/h.
By pushing the "TIMER" key 6 times consec-
(See External Motors Instructions ) Remote
utively (MAX break between one push and the
motors, whose air capacity exceeds 650m³/h
other is 3 sec.) all the leds will flash and the
at both 4th and 3rd speed , will have the fol-
calibration will be reset.
lowing by default timer control functions: The
After the next 3 cycles the downdraft will carry
suction speed is automatically switched from
out its self-calibration.
F: Timer
4th to 2nd speed, after 6 minutes operation.
If the appliance is working at 3rd speed, it is
Stand-by:
au-tomatically switched to 2nd speed, after
10 min after setting, it serves to stop the ex-
When the extractable unit is closed and the
7 mi-nutes operation. Operation speeds can
tractor motor, close the carriage and switch
light is switched off, the control panel, after
also be changed during operation. The ener-
the lights off, if they are on.
6 seconds, activates the Stand-by function,
gy consumption of the appliance in stand –
reducing the brightness of the leds.
by mode is lower than 0.5W.
The set function is signalled by the flashing
This function can be stopped by pressing ON/
LEDs "D" for the set speed.
OFF or LIGHT key.
The timer can be cancelled by pressing the
key again.
Other functions:
76
Automatic turn off:
After 4 hours of continuous working from the
The set function is signalled by the flashing
LEDs "D" for the set speed.
EN
The timer can be cancelled by pressing the
key again.
Security system:
If there is an obstacle while the extractable
Other functions:
unit is closing, the Downdraft stops closing
and rises again thanks to a security system.
Automatic turn off:
After 4 hours of continuous working from the
WARNING
last setup, the appliance turns off and closes
This operation has to be carried out by a automatically.
specialized technician.
Grease filters saturation:
After 30 hours of working, the speed indica-
tors "D" will all flash simultaneously, signaling
the grease filters saturation.
To reset this alarm, hold down the "TIMER"
button for at least 3 seconds, while the car-
riage is open.
Calibration:
The cooker-hood carries out its self-calibra-
tion every 3 complete cycles of its extractable
unit.
By pushing the "TIMER" key 6 times consec-
utively (MAX break between one push and the
other is 3 sec.) all the leds will flash and the
calibration will be reset.
After the next 3 cycles the downdraft will carry
out its self-calibration.
Stand-by:
When the extractable unit is closed and the
light is switched off, the control panel, after
6 seconds, activates the Stand-by function,
reducing the brightness of the leds.
This function can be stopped by pressing ON/
OFF or LIGHT key.
EN
Security system:
If there is an obstacle while the extractable
unit is closing, the Downdraft stops closing
76
and rises again thanks to a security system.
WARNING
This operation has to be carried out by a
specialized technician.
S-DDH1 S-DDH2
Th
sp