9. Install the cooking hob ensuring that the
opening at the rear of the product coincides
perfectly with the downdraft (refer to Fig. 9).
S-DDH1 S-DDH2
EN
INSTALLING THE FOAM GASKET
Before installing the cooking hob in its appropri-
ate seat in the worktop, apply the adhesive gas-
ket in expanded polyurethane supplied with the
product to the lower part of the cooking hob.
WARNING
Do not install the cooking hob without the
adhesive gasket!
The gasket should be attached to the appliance
in the following way:
• Remove the protective film from the gasket.
• Then, attach the gasket to the lower side of
the glass, approximately 2-3 millimetres from
the edge.
• The gasket must be attached along the entire
length of the glass edge and should not over-
lap at the corners.
• When installing the gasket, make sure that the
glass does not come into contact with any
sharp objects.
51