Table of Contents
Advertisement
1.4.1. Activating the front camera (dip 1)
If set to ON, the interface switches for 10 seconds from the rear-view camera to the front
camera input after having disengaged the reverse gear, depending on the menu
adjustments. In addition, a manual switch-over to the front camera input is possible via
keypad (short press) from any image mode.
Description of the power supply output: see chapter "Power supply output".
1.4.2. Enabling the interface's video inputs (dip 2-3)
Only the enabled video inputs can be accessed by switching through the interface's video
sources. It is recommended to enable only the required inputs. So the disabled inputs will be
skipped while switching through the video interfaces inputs.
1.4.3. Rear-view camera setting (dip 5)
If set to OFF, the interface switches to factory picture while the reverse gear is engaged to
display factory rear-view camera or factory optical park system picture.
If set to ON, the interface switches to its rear-view camera input while the reverse gear is
engaged.
1.4.4. Monitor selection (dip 7 and 8))
Dip switch setting of dip7= OFF
Dip switch setting of dip8= ON
Note: Dip4 and dip6 are out of function and have to be set to OFF!
1.5.
Settings of the 4 Dip switches (GM-LAN function – red)
All 4 dip-switches of the video interface have no function for normal use and have to be set
to OFF.
Dip position down is ON and position up is OFF.
Vehicle/Navigation
All vehicles
After each Dip-switch-change a power-reset of the video interface has to be performed!
Version 14.09.2021
Dip 1
Dip 2
Dip 3
OFF
OFF
OFF
HW:CAM(V100)/(V20+V41)
Dip 4
OFF
CI-RL4-IOR
Advertisement
Table of Contents
