Connection Of The Yellow Line In Case Of Faulty Touch Function Or Non-Off-Switching Of The Video Interface - Car-Interface.com CI-RL4-IOR Manual

2.4.1. Connection of the yellow line in case of faulty touch function or non-off-switching of
the video interface
If, after having completely connected the video interface, the touch functions fail after
disengaging reverse gear the first time, or if the interface does not switch off after reaching
vehicle's sleep mode, the yellow wire of the PNP harness has to be disconnected on the
interface side and connected as follows:
Cut the yellow wire of the PNP harness near the 10pin connector and connect it to the
vehicle's +12V S-contact terminal 86s (e.g. cigarette lighter)
Insulate the other side of the yellow cable, as it is powerded!
Attention: The fuse, installed in the yellow cable, has to be connected in every case!
Version 14.09.2021 HW:CAM(V100)/(V20+V41) CI-RL4-IOR