Audio Insertion; After-Market Front Camera - Car-Interface.com CI-RL4-IOR Manual

Table of Contents

2.7.1. Audio-insertion

This interface is only able to insert video signals into the factory infotainment. If an AV-

source is connected, the audio insertion has to be done by the factory audio AUX input or an

FM-modulator. The inserted video-signal can be activated simultaneously to each audio-

mode of the factory infotainment. If 2 AV sources shall be connected to the infotainment,

additional electronic is necessary to switch the audio signals.

The red power supply output

a front camera. If Dip 1 is set to ON (of the black 8 dips), the power supply output

gives +12V (max 3A) when reverse gear is engaged incl. 10 seconds delay after

reverse gear is disengaged.

Note: In addition, a manual switch-over to the front camera input is possible via keypad

(short press) from any image mode. The power supply output gives +12V then, too (if Dip 1 is

set to ON and the front camera input is selected).

Version 14.09.2021

ACC/front cam out 12V (max 3A)

HW:CAM(V100)/(V20+V41)

can be used to power

CI-RL4-IOR

Table of Contents