Table of Contents
Advertisement
7.3 Leveling Wing
1. The center section height should be set before
adjusting the wing sections. Make sure the
tractor is completely shut down, the cutter is
completely lowered, and the cutter and tractor
are secured in position.
2. To set the inner wing section height, adjust the
1-1/4" threaded rod on the wing adjustment
assembly to level the wings of the cutter with
the center section.
3. To raise or lower wing, back off nut "A" first then
adjust nut "B". Retighten nut "A" and lock
washer after adjustment. To lower the wing,
retract
the
threaded
wing,extend the threaded rod.
4. After the wings are set at the desired position,
retighten jamnuts to maintain height settings
LEVELING WING SECTIONS WITH CENTER
5. To set the outer wings, adjust the turnbuckle on
the wheel linkage to level the outer wings with
the inner wings.
FX-530 06/21
© 2021 Alamo Group Inc.
OPERATION
rod. To
raise
the
Operation Section 4-14
Advertisement
Table of Contents
