Table of Contents
Advertisement
http://arttel.ru
Keep-alive interval
Use NAT IP
STUN Server
Firmware Upgrade and
Provisioning
Via TFTP Server
Via HTTP Server
Config Server Path
XML Config File Password
(For
GXP280/GXP/285/GXP1200
Only)
Firmware File
Prefix/Postfix
Config File
Prefix/Postfix
Allow DHCP Option 43 and
Option 66 to override
server
Authenticate Conf File
Grandstream Networks, Inc.
This parameter specifies how often the GXP sends a blank UDP packet to the
SIP server in order to keep the "hole" on the NAT open. Default is 20 seconds.
NAT IP address used in SIP/SDP message. Default is blank.
IP address or Domain name of the STUN server. STUN resolution result will be
displayed in the STATUS page of the Web UI.
Default method is HTTP. Firmware upgrade may take up to 10 minutes
depending on network environment. Do not interrupt the firmware upgrading
process.
This is the IP address of the configured TFTP server. If selected and it is non-
zero or not blank, the GXP will attempt to retrieve a new configuration file or new
code image from the specified TFTP server at boot time. It will make up to 3
attempts before timeout and then it will start the boot process using the existing
code image in the Flash memory. If a TFTP server is configured and a new code
image is retrieved, the new downloaded image will be verified and then saved
into the Flash memory.
Note: Grandstream strongly recommends that the user upgrade firmware locally
in a LAN environment if using TFTP to upgrade. Please do NOT interrupt the
TFTP upgrade process (especially the power supply) as this will damage the
device.
The HTTP server URL used for firmware upgrade and configuration via HTTP.
For example:
http://provisioning.mycompany.com:6688/Grandstream/1.2.5.3
Here ":6688" is the specific TCP port that the HTTP server is using; omit if using
default port 80.
Note: If Auto Upgrade is set to No, GXP will only perform HTTP download once
at boot up.
IP address or domain name of firmware server.
The XML provisioning system allows Grandstream phones to perform
configuration updates via XML configuration files. Users can set the XML config
file password in the web UI of the phone.
Default is blank. If configured, GXP will request the firmware file with the
prefix/postfix. This setting is useful for ITSPs. End user should keep it blank.
Default is blank. End user should keep it blank.
Default is Yes. This allows the device to get provisioned automatically.
Default is "No". If set to "Yes", configuration file would be authenticated before
acceptance. End user should use default setting.
GXP User Manual
Firmware 1.2.5.3
Page 33 of 44
Last Updated: 03/2011
Advertisement
Table of Contents
