Table of Contents
Advertisement
Lighting the Burners
Each time you light the grill, check the following:
•
Inspect the hose before using the grill. If there is
excessive abrasion or wear, or if the hose is cut,
it must be replaced prior to using the grill. If you
need a replacement hose, contact your Cal Flame
dealer.
•
Ensure the area around the barbecue is clear of
flammable substances such as gasoline, yard de-
bris, wood, etc.
•
Ensure there is no blockage of the airflow through
the vent space located below the face of the unit.
•
When using propane gas, keep the special venti-
lation openings in the enclosure free and clear of
debris.
•
If connected to a propane cylinder, carefully in-
spect the rubber hose attached to the regulator
Electronically Lighting the Burners
1. Open the hood.
2. Keep your face as far away from the burners as
possible.
3. Press and rotate the burner knob counter
clockwise past the light position to HIGH. You
will hear a loud click as the electronic lighter
produces a spark.
4. Listen for the sound of the gas igniting. If the
burner does not light on the first try, repeat
immediately.
5. If the burner does not light after three attempts,
turn the control knobs to the OFF position.
Wait five minutes until the gas clears before
attempting to light it again.
6. Repeat the procedure or try the manual lighting
procedure below.
7. Upon successful lighting, repeat the process on
the other burners you wish to light.
8. To shut off the burners, rotate the knob and turn
to OFF. It is normal to hear a popping sound
when the burners are turned off.
P4, P5, and P6 Barbecue Grills
LTR50001137, Rev. K
before each use.
•
Ensure the propane cylinder, regulator, and rubber
hose are installed in a location not subject to heat-
ing above 125º F (51º C).
•
Ensure the burner flames burn evenly along both
sides of each burner with a steady flame (mostly
blue with yellow tipping). If burner flames are not
normal, check the orifice and burner for insects or
insect nests.
•
Ensure the in-line gas valve or gas cylinder valve
is always shut OFF when the barbecue is not in
use.
•
Do not operate the side burner with its cover
closed or the back burner with its cover installed.
Manually Lighting the Burners
WARNING: Do not use standard matches or cigarette
lighters to perform match lighting procedures.
Serious burns can occur and lighters can explode.
1. Open the hood.
2. If you have just attempted to light the burner,
allow five minutes for any accumulated gas to
dissipate.
3. Slide out the drip tray from the grill.
4. Keep your face as far away from the burners as
possible.
5. Light and insert a long stem match, holding it
near the burner ports.
6. Push in and turn the control knob just past the
LIGHT position to HIGH.
7. Listen for the sound of the gas igniting. If the
burner does not light after five seconds, turn
the control knobs to the OFF position. Wait five
minutes until the gas clears before attempting
to light it again.
8. If the burner does not light after several
attempts see Troubleshooting Guide in the back
of this manual.
17
www.cal amebbq.com
Advertisement
Table of Contents
