King Industrial KC-117C Instruction Manual page 15

INSTRUCTIONS FOR DUAL LASER GUIDE SYSTEM
USING/ADJUSTING DUAL LASER GUIDE SYSTEM
WARNING! Do not look directly at the laser beams. Do not aim the laser beams at any person or any object other than
your workpiece. Do not deliberately aim the beams into the eye of a person for any length of time. Do not use the laser
guide system aimed at a reflective workpiece, wood or rough coated surfaces are acceptable. This is to avoid the laser beams
from being reflected back at the operator.
Using the dual laser guides system;
Your laser guides are battery operated (2 x AA batteries) and
must be installed inside the laser switch/battery cover (A)
Fig.1. To remove this cover pressure must be applied to the
top and bottom, then you simply pull gently on the cover. Do
not yank the switch off, internal wires are attached to it. When
positioning the batteries, make sure they are positioned with
the correct polarity. Replace the laser/battery cover. Turn the
laser switch on to make sure the dual laser guide system
works.
1) Mark the drilling point on your workpiece.
2) Plug in the drill press and turn the motor on.
3) Switch on the laser guides and align the drilling point with the intersecting point of the laser guides.
4) Secure workpiece to the table with a vise or clamps.
5) Slowly feed the drill bit into the workpiece.
6) Switch off the dual laser guide system on completion of the drilling operation.
Adjusting the dual laser guide system;
If adjustments to the laser guides are necessary, proceed as follows;
1) Loosen set screw (A) Fig.2 (one set screw for each laser) and then slightly turn laser guide (B) Fig.2 in either direction, this
will reposition the laser beams trajectory, adjust the position of the laser guides this way until both beams intersect at the point
where the drill bit touches the workpiece. Retighten set screw (A) after each adjustment.
Caution: Remove the laser guide batteries from the battery compartment if you plan on storing your drill press for more than a
few days. If left in position, the batteries could leak and damage the laser guide assembly. Damage due to leaking batteries is
not covered under warranty.
Fig.1
Fig.2