Table of Contents
Advertisement
ADJUSTING THE TABLE SQUARE TO THE HEAD
NOTE: The combination square must be "true".
1. Insert precision round steel rod or straight drill bit approximately 3"
long into the chuck and tighten.
2. With the table raised to work height and locked to the column, place the
combination square flat on the table beside the rod or drill bit.(Fig.19).
3. If an adjustment is necessary, loosen the set screw under the bevel lock
with 3mm hex. key, then loosen the table bevel lock bolt with the open
wrench included. This adjustment is located under the work table.
4. Align the table square to the rod or drill bit by pivoting the table they
are in line.
5. Retighten table bevel lock.
6. Retighten set screw.
BEVEL SCALE
NOTE: The bevel scale has been included to provide a quick method for
beveling the table to approximate angles. If precise accuracy is necessary,
a square, or other precision measuring tool should be used to position the
table.
1. To use the bevel scale do the following: a) Loosen set screw and table
bevel lock (See step 3 above for reference). b) Move table so that desired
angle on the bevel scale is straight across from the zero line on the table.
c) Retighten table bevel lock and set screw.
DRILLING TO A SPECIFIC DEPTH
To drill a blind hole (not all the way through) to a given depth, proceed as
follows.
1. Mark the depth of the hole on the workpiece.
2. Loosen the depth scale lock.
3. With the switch OFF, bring the drill bit down until the tip of the lips of
the drill bit are even with the mark.
4. Turn the depth scale counterclockwise until it stops moving.
5. Tighten the depth scale lock.
6. The drill bit will stop at this depth until the depth scale is readjusted.
ANOTHER WAY-DEPTH SCALE
1. With the power OFF, loosen the depth scale lock.
2. Place workpiece on table. Adjust table until the tip of the drill is just a
little above the top of the workpiece, turn the depth scale
counterclockwise to zero.
3. Turn the depth scale clockwise until the depth scale indicator points to
the desired drilling depth on the depth scale.
4. Tighten the depth scale lock.
5. The chuck or drill will now be stopped after traveling downward the
distance selected on the depth scale.
ADJUSTMENTS
Table
bevel lock
Set screw
FIGURE 19
Pointer
Scale
FIGURE 20
Depth sacle
indicator
Depth scale
Mark
FIGURE 21
Table
Table
Depth scale lock
Advertisement
Table of Contents
