Related Manuals for King Industrial KC-120FX
Summary of Contents for King Industrial KC-120FX
-
Page 1: Instruction Manual
12” INDUSTRIAL WOODWORKING JOINTER MODEL: KC-120FX (220V) & KC-120FX-5 (550V) INSTRUCTION MANUAL COPYRIGHT © 2005 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC. - Page 2 IMPORTANT INFORMATION 2-YEAR KING CANADA TOOLS LIMITED WARRANTY OFFERS A 2-YEAR LIMITED WARRANTY FOR THIS 12” INDUSTRIAL JOINTER FOR INDUSTRIAL USE. PROOF OF PURCHASE Please keep your dated proof of purchase for warranty and servicing purposes. REPLACEMENT PARTS Replacement parts for this tool are available at our authorized KING CANADA service centers across Canada. For servicing, contact or return to the retailer where you purchased your product along with your proof of purchase.
-
Page 3: General Safety Instructions
GENERAL SAFETY INSTRUCTIONS 1. KNOW YOUR TOOL 12. ALWAYS WEAR SAFETY GLASSES. Read and understand the owners manual and labels affixed to the Always wear safety glasses (ANSI Z87.1). Everyday eyeglasses tool. Learn its application and limitations as well as its specific only have impact resistant lenses, they are NOT safety glasses. -
Page 4: Electrical Connections
SERIOUS INJURY! ALL ADJUSTMENTS OR REPAIRS MUST BE DONE WITH THE MACHINE DISCONNECTED FROM THE POWER SOURCE. FAILURE TO COMPLY MAY RESULT IN SERIOUS INJURY! KC-120FX POWER SUPPLY (220V-1 PHASE) WARNING: YOUR KC-120FX (220V) MUST BE CONNECTED TO A PROPERLY GROUNDED OUTLET 220V, 20-AMP, BRANCH CIRCUIT. FAILURE TO CONNECT IN THIS WAY CAN RESULT IN INJURY FROM SHOCK OR FIRE. - Page 5 UNPACKING & ASSEMBLY UNPACKING AND CLEANING THE JOINTER Remove crate panels and carefully unpack the jointer fence and all loose items (inside dust chute) from the wooden crate. Remove the protective coating from the machined surfaces of the jointer. This coating may be removed with a soft cloth moistened with kerosene (do not use acetone, gasoline, or lacquer thinner for this purpose).
-
Page 6: Fence Operation
OPERATING CONTROLS & ADJUSTMENTS TURNING JOINTER ON & OFF The On/Off switch is conveniently located on a post, behind the jointer fence, for easy accessibility. To start the jointer, press the start button (A) Fig. 7, and to stop the jointer, press the stop button (B). FENCE OPERATION Moving fence forward or backward The fence (A) Fig. - Page 7 OPERATING CONTROLS & ADJUSTMENTS INFEED TABLE ADJUSTMENTS To raise or lower the infeed table, loosen table lockhandle (A) Fig. 12, and move the table raising and lowering hand lever (B), up or down until the table is at the desired position and tighten table lockhandle (A). NOTE: The table lockhandle (A) can be repositioned by pulling out the handle and repositioning it on the serrated nut located under the handle.The depth of cut of the infeed table (position of table in relationship with the cutting circle) can be read with the pointer and scale (C).
-
Page 8: Adjusting Belt Tension
ADJUSTMENTS ADJUSTING BELT TENSION The jointer comes with two V-belts installed and properly tensioned to the cutterhead and motor pulley. If it becomes necessary to adjust belt tension, proceed as follows: 1. DISCONNECT THE MACHINE FROM THE POWER SOURCE. 2. Loosen knob (A) Fig.16 and pull the handle latch (B) upwards and open rear hinged door (C). -
Page 9: Removing, Replacing And Resetting Knives
ADJUSTMENTS REMOVING, REPLACING AND RESETTING KNIVES If the knives are removed from the cutterhead for replacement or regrinding, care must be used in removing and replacing them as follows: 1. DISCONNECT THE MACHINE FROM THE POWER SOURCE. 2. Be extremely careful that your hands do not come in contact with the cutterhead.