Connecting The Dishwasher To The Electricity; Substructure - Hanseatic WQP12-J7635E User Manual

2. Check that the connection to the water
tap is sealed. Turn on the water tap slow-
ly and ensure that no water is escaping.
Then close the valve again.
Connecting the dishwasher to
the electricity
WARNING!
Risk of electric shock!
Faulty electrical installation or excessive
mains voltage may result in an electric
shock.
Prior to connecting the dishwasher,
■
ensure that you have page EN-6 tak-
en note of all the safety instructions
and adhered to them.
Fire hazard!
Never use multi-socket adapters,
■
multi-socket strips, travel adapters or
the like.
Depending on the recess into which the
dishwasher will be installed, the dishwasher
should be connected before or after installa-
tion.
– For the electrical connection of the dish-
washer, a professional must install an
earthed power socket with its own fuse of a
sufficient size (220–240 V~ / 50 Hz / 10 A).
– The plug must be installed in such a way
that the recess into which the dishwasher
will be fitted is deep enough even when the
plug is plugged in.
– Do not use a multi-socket extension cable,
multi-socket plug, travel adapter, extension
cable or similar.
– We recommend using a pulse-sensitive re-
sidual current device (RCD).
• Connect the mains plug to the socket.
Set-up, connection and initial start-up

Substructure

If you are setting up your dishwasher as a
freestanding appliance, continue with „Water
hardness" on page EN-27.
NOTICE
Risk of damage!
Selecting the wrong screws can dam-
age the worktop.
Select the correct screws with the ap-
■
propriate screw length.
Use the enclosed screws.
■
Requirements:
– Only install the dishwasher underneath a
continuous worktop which is joined to the
units adjacent to the dishwasher.
– Maintain sufficient distance from the walls
and adjacent appliances. The recess di-
mensions must at least correspond to the
details in the diagram above, 'recess di-
mensions'.
1. If you have not already done so, remove
cardboard, polystyrene and adhesive
strips from the inside of the dishwasher.
2. Loosen both screws on the reverse side
of the covering panel and remove them.
Page EN-25