Connecting The Dishwasher To The Electricity; Installing The Dishwasher - Hanseatic HGTI4582E97736BS User Manual

Page EN-30 Installation, assembly, connection and initial commissioning
For water supply, you need a water tap with
a ¾ inch screw connector.
1. Screw the safety valve's lock nut to the
tap hand-tight.
2. Check that the connection to the water
tap is sealed. Turn on the water tap slowly
and ensure that no water is escaping.
3. Then close the tap again.
Connecting the dishwasher to
the electricity
WARNING!
Electric shock / fi re hazard!
Prior to connecting the dishwasher,
■
ensure that you have page EN-4 tak-
en note of all the safety instructions
and adhered to them.
Depending on the recess into which the dish-
washer will be fitted, the dishwasher should
be connected before or after fitting.
– For the electrical connection of the dish-
washer, a professional must install an
earthed power socket with its own fuse of
a sufficient size (230 V~/50 Hz/10 A).
– The plug must be installed in such a way
that the recess into which the dishwasher
will be fitted is deep enough even when the
plug is plugged in.
– Do not use a multi-socket extension cable,
multi-socket plug, travel adapter, extension
cable or similar.
– We recommend using a pulse-sensitive re-
sidual current device (RCD).
• Insert the mains plug into the socket.

Installing the dishwasher

NOTICE
Risk of damage!
Selecting the wrong screws can dam-
age the front panel.
Use the supplied screws (i) or screws
■
of the appropriate length.
1. To protect the worktop against conden-
sation, affix the enclosed protective film
(e) to the underside of the worktop.
This will help you minimise damage
to the worktop from the outflow of hot
steam.
2. Insert the two mounting brackets (g)
into the front slots on the top of the dish-
washer so that you can screw the dish-
washer to the worktop subsequently.
(e)
(g)