Connecting The Inlet Hose; Connecting The Dishwasher To The Electricity - Hanseatic HG6085E127635W Manual

Hide thumbs Also See for HG6085E127635W:
Table of Contents

Advertisement

Available languages

Available languages

Page EN-26
Setup or under-worktop installation and connection
Connect the outlet hose's outlet as follows:
– Option A:
Direct conn ection to the odour seal (si-
phon) of your washing/dishwashing basin.
The outlet hose must be a maximum of
1000 mm above the floor.
– Option B:
Connection to a floor drain.

Connecting the inlet hose

NOTICE
Risk of damage!
The dishwasher is set up for a water
pressure of 0.4 bar to 10 bar (0.04 MPa
to 1.0 MPa). Water must always be able
to run freely into the dishwasher, oth-
erwise this can damage the appliance.
For water pressure of less than 10 bar,
install a pressure reducer (in case of
doubt, seek information from the wa-
ter supply company).
Never connect the appliance to the
water tap or the mixing arm of a wa-
ter heater (e.g. continuous fl ow heat-
er, pressure-free boiler etc.).
Ensure that the inlet hose is correctly
connected and is not kinked or dam-
aged.
Ø ≥ 40 mm
Do not damage the inlet hose; it con-
tains electrical components. If the in-
let hose is damaged, contact our ser-
vice department (see page EN-33).
3
¾ inch
Inlet hose
For water supply, you need a water tap with
a ¾ inch screw connector.
1. Screw the safety valve's lock nut to the
tap hand-tight.
2. Check that the connection to the water
tap is sealed. Turn on the water tap slow-
ly and ensure that no water is escaping.
Then close the tap again.
Connecting the dishwasher to
the electricity
WARNING!
Electric shock / fi re hazard!
Prior to connecting the dishwasher,
ensure that you have page EN-5 tak-
en note of all the safety instructions
and adhered to them.
Depending on the recess into which the dish-
washer will be fitted, the dishwasher should
be connected before or after fitting.
– For the electrical connection of the dish-
washer, a professional must install an
earthed power socket with its own fuse of
a sufficient size (230 V~/50 Hz/10 A).
– The plug must be installed in such a way
that the recess into which the dishwasher
will be fitted is deep enough even when the
plug is plugged in.

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Hg6085e127635s

Table of Contents