Error Indicators - Hanseatic WQP12-J7635E User Manual

Page EN-30 Troubleshooting table
Problem
The dishes are not com-
pletely clean.

Error indicators

Code
E1 : It takes too long for the
water to fill up.
E3 : The heating element is
defective.
E4
: Water overflow
E8 : Internal fault
Possible cause
There are food scraps which
are encrusted onto the dish-
es.
The dishes have not been
stacked optimally.
You have selected the incor-
rect dishwashing programme.
The dishwasher detergent is
incorrectly dosed.
The water pressure is too low. Turn the water tap on completely.
The spraying arm can not ro-
tate unhindered.
The nozzles on the spraying
arm are blocked/calcified.
Solution
Turn the water tap on completely.
Arrange the inlet hose properly so that it is not kinked (see „Connect-
ing the inlet hose" on page EN-24).
Ensure that the water pressure is correct. See „Technical specifi-
cations" on page EN-32.
Have the appliance checked and repaired.
Switch off the tap. Find the gap in the seal (or have someone find it)
and repair the leak (or have it repaired).
Have the appliance checked and repaired.
Solution
Soak dirty dishes prior to washing
the dishes.
Stack the dishes in such a way that
all parts can be reached by the wa-
ter jets (see „Loading the dishwash-
er" on page EN-13).
Select the correct dishwashing
programme (see „Dishwasher pro-
gramme table" on page EN-16).
Use the correct dosage of dish-
washer detergent (see „Dishwasher
programme table" on page EN-16).
Ensure that no dishes are impeding
the motion of the spraying arm.
Clean the nozzles (see „Cleaning
the spraying arm" on page EN-22).