Adding Rinse Aid - Hanseatic WQP12-J7635E User Manual

Dishwasher detergents, rinse aids and dishwasher salts
(24)
2. Place a multitab in the compartment.
3. Push the cover of the compartment
closed so that the closure clicks into place
once again.

Adding rinse aid

NOTICE
Risk of damage!
Using an excessive amount of rinse aid
can lead to increased foaming and can
compromise the rinsing results.
Wipe away rinse aid which has over-
■
fl owed immediately.
Take note of the markings for the
■
maximum fi ll quantities ("max") in
the rinse aid chamber.
Using unsuitable substances can cause
damage to the dishwasher.
Only put rinse aids which are suita-
■
ble for dishwashers into the rinse aid
chamber.
You do not need to add rinse aid to the
dishwasher detergent compartment,
– if you are only using multitabs which al-
ready contain rinse aid.
– if the water hardness in your area is in the
0–5° dH range.
(5)
Prior to the first use, and when the display
reading "Add rinse aid" lights up, add
rinse aid.
As rinse aid is automatically dispensed during
operation, it ensures that the dishes are spot-
free and accelerates the drying process.
(25)
1. Turn the cover of the dishwasher salt
compartment (25) a quarter turn in an an-
ti-clockwise direction and remove it.
2. Fill the water tank to the "max" mark in
the opening. The adjacent display window
will then turn black.
3. Wipe away any rinse aid which has spilt
immediately so that you don't compro-
mise the rinsing results and to avoid in-
creased foaming.
4. We would recommend that you do not
change the dosage that was set by the
factory initially. Only correct the dosage if
you are not satisfied with the rinsing re-
sults (see next page).
5. Replace the cover on the opening of the
compartment and turn it in a clockwise
direction.
Page EN-11
(5)