Installation - Integra PIPETBOY acu 2 Operating Instructions Manual

PIPETBOY acu 2 - Operating instructions V17
3

Installation

3.1 Charging the battery
A full charge takes 3.5 hours. Before the first use, PIPETBOY acu 2 should be charged
until the battery charge indicator (4) turns green, showing that the battery is full.
When the battery charge indicator (4) starts flashing red, PIPETBOY acu 2 can be used
for around 100 pipetting cycles before shutting down. It should thus be recharged
immediately.
PIPETBOY acu 2 has an integrated protection: it will not overcharge even if it is connected
to power for indefinite time. To avoid unnecessary power consumption, it is recommended
to unplug the power supply when the charge indicator is green. PIPETBOY acu 2 can be
used while it is being charged.
The battery charge indicator provides various information:
Battery charge indicator
Flashes red
Is red and power supply is connected
Is green and power supply is connected
Flashes alternately red and green
3.2 Replacing the battery
3.3 Mounting of the wall mount
The wall mount serves to park PIPETBOY acu 2.
To mount the wall mount, remove the protective foil from the adhesive tape at the back of
the holder. Hold it with the sign <up> facing upwards and press it to the desired place.
Make sure that the surface onto which the wall mount is mounted is smooth, clean and
grease-free. Wait 24 hours before using the wall mount for the first time. Alternatively the
wall mount can be fixed with the included screws.
www.integra-biosciences.com
a
1) Move the lid of the battery compartment upwards and
remove it (a).
2) Replace
INTEGRA Biosciences rechargeable battery (see "7
Accessories" on page 16) and make sure that it is
inserted with the correct polarity (+/-).
3) Close the battery compartment with the lid (a).
Battery status and information
Battery is low. Charging is needed.
Battery is being charged.
Battery is fully charged.
Battery error. Check if the correct type of
battery with correct polarity (+/-) and/or
power supply are used.
the old battery
Installation
with an original
9