Installation - Integra VACUSIP Operating Instructions Manual

VACUSIP - Operating instructions V04
3

Installation

3.1 Power supply
Insert the mains adapter cable into the VACUSIP mains connection socket (13) and plug
it into the power source.
W
ARNING
Use an original INTEGRA Biosciences mains adapter only (see "6.1
Specifications" on page 12 for voltage requirements)
3.2 Charging of VACUSIP battery model
A full charge takes 5 hours. Before the first use, VACUSIP should be charged for at least
5 hours.
When the LED (2) starts to blink green, the battery needs to be recharged immediately to
prolong battery life. VACUSIP has an integrated overcharge protection.
VACUSIP can be used while it is being charged.
3.3 Set-up
3.3.1 Installing the VACUSIP hand operator mount
Find the enclosed stainless steel rod (4) and push it into the opening (12).
Attach the hand operator mount (6) to the top of the stainless steel rod (4).
W
ARNING
Do not carry VACUSIP by holding the rod or the hand operator mount. Always
grab the instrument at the back to carry it around.
3.3.2 Assembling the hand operator
3.3.3 Connecting the filter
Attach the shorter silicone tubing to the filter (9) and then plug the filter into the silicone
filter adapter with the blue side facing the instrument.
VACUSIP should never be used without a filter.
www.integra-biosciences.com
Insert the inner part in the silicone
cover, as shown on the picture
beside.
Installation
7