Table of Contents
Advertisement
7
Chapter 7 Tutorial
Modulation
Modulation
Modulation is the process of modifying a high-frequency signal (called the
carrier signal) with low-frequency information (called the modulating
signal). The carrier and modulating signals can have any waveshape,
but the carrier is usually a sine waveform.
The two most common types of modulation are amplitude modulation
(AM) and frequency modulation (FM). These two forms of modulation
modify the carrier's amplitude or frequency, respectively, according to
the instantaneous value of the modulating signal. Pulse width
modulation (PWM) is provided for pulse waveforms only. In PWM, the
pulse width or duty cycle of the pulse waveform is varied according to the
modulating signal.
The function generator will accept an internal or external modulation
source. If you select the internal source, the modulated waveform is
generated by a secondary DDS synthesizer. If you select the external
source, the modulated waveform is controlled by the signal level present
on the function generator's rear-panel Modulation In connector.
The external signal is sampled and digitized by an analog-to-digital
converter (ADC). With either modulation source, the result is a stream of
digital samples representing the modulating waveform.
Amplitude Modulation (AM)
The function generator implements a form of AM called "double-
sideband transmitted carrier." This is the type of modulation used by
most AM radio stations.
Amplitude Modulation
326
Modulating Signal
Modulated Carrier
(100% depth shown)
Advertisement
Table of Contents
