To Prepare The Function Generator For Use - Keysight 33210A User Manual

To Prepare the Function Generator for Use

1 Check the list of supplied items.
Verify that you have received the following items with your instrument.
If anything is missing, please contact your nearest Keysight Sales Office.
• Power cord (for country of destination).
• Certificate of Calibration.
• Keysight 33210A Product Reference CD (product software,
programming examples, and manuals).
• Keysight Automation-Ready CD ( Keysight IO Libraries Suite).
• USB 2.0 cable.
Note: All of the 33210A product documentation is provided on the Keysight
33210A Product Reference CD that comes with the product, and is also
available on the Web at
(hardcopy) manuals are available as an extra cost option.
Power 2 Connect the power cord and turn on the function generator.
Switch
The instrument runs a short power-on self test, which takes a few
seconds. When the instrument is ready for use it displays a message
about how to obtain help, along with the current GPIB address and USB
identification string. The function generator powers up in the sine wave
function at 1 kHz with an amplitude of 100 mV peak-to-peak (into a 50Ω
termination). At power-on, the Output connector is disabled. To enable the
Output connector, press the
If the function generator does not turn on, verify that the power cord is
firmly connected to the power receptacle on the rear panel (the power-line
voltage is automatically sensed at power-on). You should also make sure
that the function generator is connected to a power source that is energized.
Then, verify that the function generator is turned on.
If the power-on self test fails, "Self-Test Failed" is displayed along with an
error code. See the Keysight 33210A Service Guide for information on
error codes, and for instructions on returning the function generator to
Keysight for service.

To Prepare the Function Generator for Use

www. keysight .com/find/33210A. Printed
key.
Chapter 1 Quick Start
4
15
1