Connection To The Head-Unit - Power / Can - r.LiNK CI-RL3-R40 Manual

Video-inserter with 2 video inputs, rear-view camera input and can control

Table of Contents

2.5.

Connection to the head unit – power / CAN

Connect the 12pin interface cable's female 12pin

connector to the male 12pin connector of the video-

interface.

Connect the female 10pin connector of the 20pin

PNP harness to the male 10pin connector of the

video interface

Remove the female 20pin connector of the vehicle

harness from the rear side of the Head-unit and

connect it to the male 20pin connector of the

20pin PNP harness.

Connect the female 20pin connector of the 20pin PNP harness to the male 20pin

connector of the head-unit.

Connect the single red wire

ACC-out (max 3A)

and the purple coloured wire

Manual ACC

of the 12pin interface cable both to

S-contact terminal 86s +12V

(e.g. glove compartment

illumination).

Note: If the interface does not power off (all LED off!) when vehicle is in sleep-mode, the

yellow wire has to be cut and the wire's end which leads into the video-box has to be

connected with external ACC.

Version 16.03.2020

HW: CAM(V97)/(V30)

CI-RL3-R40

Table of Contents