Load Factory Defaults; Reboot System; Command Line Ftp; Figure 23-5 Confirm Load Factory Defaults - ZyXEL Communications Dimension GS-3012 User Manual

Dimension GS-3012 Gigabit Ethernet Switch

23.5 Load Factory Defaults

Press the Click Here button next to Load Factory Defaults to clear all switch configuration information you
configured and return to the factory defaults. The following message appears.

Figure 23-5 Confirm Load factory Defaults

Click OK to go to the next screen.

Figure 23-6 Restart Switch After Load Factory Defaults

Click OK to begin resetting all switch configurations to the factory defaults and then wait for the switch to restart.
This takes up to two minutes. If you want to access the switch web configurator again, you may need to change the
IP address of your computer to be in the same subnet as that of the default switch IP address (192.168.1.1).

23.6 Reboot System

Reboot System allows you to restart the switch without physically turning the power off. Press the Click Here
button next to Reboot System to display the next screen.

Figure 23-7 Confirm Restart The Switch

Click OK to see the screen as shown in Figure 23-6. Click OK again and then wait for the switch to restart. This
takes up to two minutes. This does not affect the switch's configuration.

23.7 Command Line FTP

This section shows some examples of uploading to or downloading files from the switch using FTP commands.
First, understand the filename conventions.
Maintenance 23-3