Dimension GS-3012 Gigabit Ethernet Switch
This command shows the switch's GVRP settings.
An example is shown next.
GS-3012 # show vlan1q gvrp
GVRP Support
---------------------
gvrpEnable = YES
GVRP Support
30.4.4
Enable GVRP
Syntax:
vlan1q gvrp
This command turns on GVRP in order to propagate VLAN information beyond the switch.
30.4.5
Disable GVRP
Syntax:
no vlan1q gvrp
This command turns off GVRP so that the switch does not propagate VLAN information to other switches.
30.5 Port VLAN Commands
You must configure the switch port VLAN settings in config-interface mode.
30.5.1
Set Port VID
Syntax:
pvid <VID>
where
<VID>
=
This command sets the default VLAN ID on the port(s).
The following example sets the default VID to 200 on ports 1 to 5.
GS-3012 (config)# interface port-channel 1-5
GS-3012 (config-interface)# pvid 200
30-4
Figure 30-4 garp status Command Example
Specifies the VLAN number between 1 and 4094
Figure 30-5 vlan1q port default vid Command Example
IEEE 802.1Q Tagged VLAN Commands