Table of Contents
Advertisement
Prestige 202H User's Guide
Chapter 9
Static Route Setup
This chapter shows how to set up static routes.
9.1
Static Route Overview
Static routes tell the Prestige routing information that it cannot learn automatically through other means. This
can arise in cases where RIP is disabled on the LAN or a remote network is beyond the one that is directly
connected to a remote node.
Each remote node specifies only the network to which the gateway is directly connected and the Prestige has
no knowledge of the networks beyond. For instance, the Prestige knows about network N2 in the following
diagram through remote node Router 1. However, the Prestige is unable to route a packet to network N3
because it does not know that there is a route through remote node Router 2. The static routes are for you to
tell the Prestige about the networks beyond the remote nodes.
Figure 9-1 Sample Static Routing Topology
Remote Node TCP/IP Configuration
9-1
Advertisement
Table of Contents
