Table of Contents
Advertisement
21.2.1 Backup Configuration
Follow the instructions as shown in the next screen.
To transfer the configuration file to your computer, follow the procedure
below:
1. Launch the FTP client on your computer.
2. Type "open" and the IP address of your system. Then type "root" and
SMT password as requested.
3. Locate the 'rom-0' file.
4. Type 'get rom-0' to back up the current router configuration to
your computer.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on backup using TFTP (note that you must remain
in this menu to back up using TFTP), please see your user manual.
Figure 21-1 Menu 24.5 System Maintenance – Backup Configuration
21.2.2 Using the FTP Command from the Command Line
Step 1.
Launch the FTP client on your computer.
Step 2.
Enter "open", followed by a space and the IP address of your Prestige.
Step 3.
Press [ENTER] when prompted for a username.
Step 4.
Enter your password as requested (the default is "1234").
Step 5.
Enter "bin" to set transfer mode to binary.
Step 6.
Use "get" to transfer files from the Prestige to the computer, for example, "get rom-0
config.rom" transfers the configuration file on the Prestige to your computer and renames it
"config.rom". See earlier in this chapter for more information on filename conventions.
Step 7.
Enter "quit" to exit the ftp prompt.
21.2.3 Example of FTP Commands from the Command Line
Firmware and Configuration File Maintenance
Menu 24.5 - System Maintenance - Backup Configuration
Press ENTER to Exit:
Prestige 202H User's Guide
21-3
Advertisement
Table of Contents
