Table of Contents
Advertisement
Prestige 202H User's Guide
Step 6.
Enter 1 to configure the first filter rule (the only filter rule of this set). Make the entries in this
menu as shown in the following figure.
Filter #: 9,1
Filter Type= TCP/IP Filter Rule
Active= Yes
IP Protocol= 6
Destination: IP Addr= 0.0.0.0
Source: IP Addr= 0.0.0.0
TCP Estab= No
More= No
Action Matched= Drop
Action Not Matched= Forward
Press ENTER to Confirm or ESC to Cancel:
There are no
more rules to
check.
Select Drop here so that the
packet will be dropped if its
destination is the telnet port.
Step 7.
Type 1 to configure the first filter rule. Make the entries in this menu as shown next.
18-18
Menu 21.1.9.1 - TCP/IP Filter Rule
IP Source Route= No
IP Mask= 0.0.0.0
Port #= 23
Port # Comp= Equal
IP Mask= 0.0.0.0
Port #=
Port # Comp= None
Log= None
Figure 18-14 Sample Filter Menu 21.1.9.1
Press [SPACE BAR] to choose this
filter rule type. The first filter rule
type determines all subsequent filter
types within a set.
Select Yes to make the rule active.
6 is the TCP protocol.
The port number for the telnet
service (TCP protocol) is 23. See
RFC-1060 for port numbers of well-
Select Equal here
known services.
as we are looking
for packets going
to port 23 only.
Select Forward here so that the packet will be forwarded if
its destination is not the telnet port and there are no more
rules in this filter set to check. Select Next if there are
more rules to check.
Filter Configuration
Advertisement
Table of Contents
