ZyXEL Communications Prestige 202H User Manual page 60

Prestige 202H User's Guide
FIELD
Max Number of
Registered
Users
Incoming Data
Call Number
Matching
Start IP
End IP
Operation
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to Confirm..." to save
your configuration, or press [ESC] at any time to cancel.
5-8
Table 5-2 Configuring NetCAPI
When you want to use NetCAPI to place outgoing calls or to listen to incoming calls,
you must start RVSCOM on your computer, and RVSCOM will register itself to the
Prestige. This option is the maximum number of clients that the Prestige supports at
the same time. The default value is 4.
This field determines how incoming calls are routed. Select NetCAPI if you want to
direct all incoming data calls to NetCAPI. Select Subscriber Number (MSN) if you
want to direct all incoming call to the Prestige only when the incoming phone number
matches the ISDN DATA number. If the incoming phone number does not match the
ISDN DATA number, then the call will be routed to NetCAPI. Select Called Party
Subaddress if you want to direct all incoming calls to the Prestige only when the
incoming call matches the subaddress of ISDN DATA. If the incoming call does not
match the subaddress of ISDN DATA, then the call will be routed to NetCAPI.
Refers to the first IP address of a group of NetCAPI clients. Each group contains
contiguous IP addresses
Refers to the last IP address in a NetCAPI client group.
Select Incoming if you wish to grant incoming calls permission. Select Outgoing if
you wish to grant outgoing calls permission. Select Both if you wish to grant both
incoming calls and outgoing calls permissions. Select None if you wish to deny all
calls.
DESCRIPTION
ISDN Setup