Operation Instructions Basic - Dake SB-250V Owner's Manual

1. BASIC OPERATION (PROCEDURE)
To show greater detail
Chuck guard is in the open position in
photos. CHUCK GUARD MUST IN
PLACE DURING OPERATION!
Drill / Chuck Installation:
POWER MUST BE OFF BEFORE
MAKING ANY ADJUSTMENTS!
TURN POWER OFF! Before inserting
drill bits, chucks or arbors, always clean
out spindle hole and taper hole with a
clean cloth.
Open chuck jaws completely by turning
attached chuck key counter-clockwise
until the jaws are fully opened.
To install the chuck to the arbor tightly,
slide the chuck into the taper forcing it
into the spindle with by hand. Place a
block of wood on the table then lower the
spindle to make contact with the wood
and press the chuck tightly into the
spindles taper.
Install a taper shaft drill bit into the taper
the same way as you would the chuck. If
an adaptor is used it must fit the taper
correctly and the bit must fit snug in the
adaptor.
Installation of drill bits in the chuck:
A drill bit with a shaft of at least 1" long
should be used to allow correct chuck jaw
contact. If shaft length is less than 1" do
not insert bit as far into the chuck where it
allows jaw contact with drill flutes. Center
drill bit onto the chuck and tighten the
chuck securely with the chuck key.
7