Table of Contents
Advertisement
Familiarize yourself with the controls before operating.
Emergency stop button
When this is pressed the power to the motor and controls is disconnected. The
frequency drive stores energy this will remain lit for about 20 seconds.
Spindle direction
Turn the spindle direction switch to the desired direction forward, reverse or stop. If
the emergency stop button is pushed or if the power is lost you will have to move
this to stop (TO RESET) then to desired spindle direction.
Stop
This is used when you would like the spindle to stop.
Forward
This is used for standard drilling and tapping operations
Reverse
This is used for left hand tapping and to retract a tap during tapping operations.
Spindle speed
The black dial in the upper right hand corner controls the spindle speed. This will
change the speed in forward and reverse directions.
Warning!!!
Avoid stopping the motor under load or stalling the motor. This could damage
the electrical components.
Spindle speed dial
Spindle direction dial
Emergency stop button
5
Advertisement
Table of Contents
