Selecting Voices From A Voice Disk (Optional) - Yamaha Electone EL-900 Owner's Manual

NOTE:
The EL-900 can read the data from the EL-90/
87 Voice Disk.
NOTE:
Any one of the voice sections can be used
here. Make sure that the volumes of all
other voices are set to off (the minimum
value).
8
Pressing these buttons steps through the voice
numbers; the name of each voice appears on
the display as well. Refer to the list included
with your Voice Disk for voice numbers and
names.
118
5 Selecting Voices From a Voice
Disk (Optional)
You can also load voices from optional Voice Disks to the 16 User voices
in the Voice Menu.
To do this:
1
Hold down the VOICE EDIT button in the DISPLAY SELECT section
and simultaneously press any one of the panel voice buttons.
2
Select the VOICE DISK page with the Page buttons.
The message ﾒInsert Voice Disk!!ﾓ appears and prompts you the
operation.
3
Insert the Voice Disk into the disk slot under the Music Disk Recorder.
The voice number and name of the Voice Disk appears.
VOICE DISK Page
4
Using any of the Data Control button pairs, select the voice you wish
to load.
5
Play the keyboard to check the sound of the voice. Select other voices
(as you did in step #4 above) and check those sounds as well.
6
If you want to save the current voice to a User Voice space, select the
previous page, ﾒSAVEﾓ with the Page buttons.
7
Press the Data Control button that corresponds to the User Voice
number you wish to save to.
Press one of the four Data Control buttons below [Save] in the display
to save the voice, or one of the four buttons below [Cancel] to abort
the operation and return to the previous display.
When the voice has been saved, a ﾒcompleted!!ﾓ message appears.
PAGE
PAGE