Pitch; Feet; Pan; Reverb - Yamaha Electone EL-900 Owner's Manual

NOTE:
Horizontal Touch is not available on the
Pedalboard.
NOTE:
Horizontal Touch may affect not only the
pitch but the timbre on some voices in the
Lead Voice 2 section.
4
NOTE:
No reverb can be obtained even though
you raise the level here, unless you raise
the total reverb level using the panel
Reverb buttons (page 52).
1
-1
46
2 PITCH (Horizontal Touch)
Horizontal Touch allows you to controls the pitch by holding down the keys and
pressing them laterally. In general the faster (and wider) you press the keys
laterally (right and left) the faster (and greater) the pitch change becomes, within
the range of ｱ one octave. You can use this function combined with the Touch
Tone described above to play a unique performance that has not been possible
before.

3 FEET

Determines the octave setting of the voice. PRESET is the original (factory)
setting; 4' is the highest and 16' is the lowest. 2' setting is added to the Pedal
Voice sections.

4 PAN

Determines the position of the voice in the stereo image. Seven pan positions
are available.
5 REV. (REVERB)
Determines the amount of reverb applied to each Voice section.
Range: 0-24
6 VOL. (VOLUME)
Fine adjustment of the voice volume. See page 27 for more information.
Voice Condition [PAGE 2]
Press the Page buttons to select PAGE 2.
1
1 EFFECT
1
-2
1
-3
Determines the effect type applied to each voice section. The settings and
1
-4
adjustments for the effects are also made from the Effect Set pages. (For more
1
-5
1
information, see page 48.)
-6
1
-7
1
PRESET:
-1
Selects the original (factory) effect.
1
OFF:
-2
Cancels the effect.
1
TREM. (TREMOLO):
-3
Selects Tremolo/ Chorus. See page 57 for the details of the Tremolo/
Chorus setting.
PAGE
2