Yamaha Electone EL-900 Owner's Manual page 103

5) Changing the Tempo
You can change the tempo of the song as the song is playing on
the M.D.R. by holding down the SHIFT button and pressing the
TEMPO + or TEMPO - button. (The Tempo dial on the Electone
panel cannot be used to change the tempo on the Music Disk
Recorder.)
Each press of the button slows down or speeds up the tempo by a
small amount. Changing the tempo does not change the pitch of
the music.
To restore the original recording tempo of a song, hold down the
SHIFT button and simultaneously press both TEMPO buttons.
Indicates faster tempo
Indicates original tempo
Indicates slower tempo
RECORD
UPPER LOWER PEDAL CONTROL UPPER LOWER
SONG FROM TO
REPEAT SONG COPY
PAUSE STOP PLAY SONG SELECT
– TEMPO +
MUSIC DISK RECORDER
NOTE:
When tempo is changed, the LED display indicates the
change as a percentage of the original recorded tempo
(100). Values less than 100 indicate a slower tempo;
values greater than 100 indicate a faster tempo.
RECORD PLAY
UPPER LOWER PEDAL CONTROL UPPER LOWER
SONG FROM TO
SONG COPY
REPEAT
PAUSE STOP PLAY SONG SELECT
– TEMPO +
MUSIC DISK RECORDER
NOTE:
Tempo changes remain in effect even through changes
in song number. If you have changed the tempo in one
song, you should perform the above step to restore the
original tempo before playing another song. Turning
the power switch off and on again also restores the
original tempo.
PLAY
PEDAL CONTROL SHIFT
SONG DEL.
RECORD CUSTOM PLAY
FORMAT
PEDAL CONTROL SHIFT
SONG DEL.
RECORD CUSTOM PLAY
FORMAT
7
103