Logic Controls PDX3 Series User Manual page 27

Set cursor on. Default set.
10. Cursor Off <16>
Set cursor off.
11. Reset <1B> <49>
All characters are erased and all settings are turned to the power-on reset conditions.
12. Clear <0E>
All displayed characters are cleared. The cursor does not move.
13. Alphanumeric Message Scroll <05> <Data> <0D>
A message of up 45 characters will be continuously scrolled on the first line of the
display. The message will continue to scroll until another attention code is received by the
display.
14. Down Load Font <1B> <43> <X> <F> <F> <F> <F> <F>
Allows a programmer to assign a keyboard key (00 Hex to FF Hex) a different style font.
The <1B> <43> represents the command code;
The <X> represents the selected key;
The <F> represent the 5 segments which will make up the special font.
15. Set pass-through Code <01>
Set line display on pass-through mode. All data codes will be by-pass to the peripheral
device when the line display on direct display mode.
16. Set direct display codes <21> <23> <02>
Set line display on direct display mode. Default mode.
<Data>:
No more than 45 characters.
24