Logic Controls PDX3 Series User Manual page 35

12. Vertical Scroll Mode <12>
After writing the characters up to the last position of the second row, all characters
displayed in the second row are shifted to the upper row (first row), clearing the second
row. Default mode.
13. Cursor On <13> or (19) or {^S}
Turn on the cursor.
14. Cursor Off <14> or (20) or {^T}
Turn off the cursor.
15. Down Line Load <1B> <75> <74> <63> Select <0D>
N/A.
16. Pass-Through Mode <1B> <64>
This command is used in Direct to pole mode to begin passing data through to the
attached device.
17. Direct To Pole Display Mode <1B> <1E>
Enter or return to direct mode to display characters on pole display.
18. Reset Display <1F>
The display will be cleared and reset to the default of <DC2> mode (Vertical Scroll). The
cursor will be positioned to the first position on the top line.
19. Flashing Text Start <0F>
Start blinking text.
20. Flashing Text End <0E>
Stop blinking text.
21. Brightness <04> <n>
Brightness level (n = level).
n = <20>, 20%
n = <40>, 40%
n = <60>, 60%
n = <FF>, 100%
32