Table of Contents
Advertisement
12. STANDARD ADJUSTMENTS
12-3. Presser foot height
12-4. X-over seam sensor correction
Be sure to carry out this procedure when replacing the presser foot.
(1)
(2)
75
The standard height of the presser foot (1) is 6 mm when the
presser foot (1) is raised by means of the lifting lever (2).
1. Loosen the nut (3), and then turn the adjustment screw (4)
so that there is no pressure applied to the presser foot.
2. Raise the presser foot (1) by using the lifting lever (2).
3. Remove the rubber cap (5) from the face plate.
4. Loosen the bolt (6) and then move the presser bar (7) up
or down until the presser foot (1) is at the standard height
of 6 mm.
5. Tighten the bolt (6).
6. Install the rubber cap (5).
7. Adjust the presser foot pressure using the presser
adjusting screw (4), and then tighten the nut (3).
0915D
1. Turn on the power.
2. Press the menu key (1).
3. Select the "X-over seam sensor correction" key (2).
4. Turn the machine pulley to set the upper shaft position to
between 110 and 290 degrees.
5. Lower the presser foot.
6. Press the OK key (3).
(3)
S-7300A
Advertisement
Table of Contents
