Brother S-7300A Instruction Manual page 95

Single needle direct drive lock stitcher with electronic feeding system and thread trimmer

Hide thumbs Also See for S-7300A:

Table of Contents

2mm

0956D

0957D

10. Set the maximum meshing amount for the upper and

lower knives to 2 mm.

* Turn the thread trimmer lever (1) to align the tip of the

upper knife (10) with the center of the index mark (14) on

the lower knife (6).

* Make sure that the tip of the upper knife (10) does not go

past the index mark (14).

11. Tighten the screw (2) of the thread trimmer lever (1).

* Make sure that there is no play in the thrust direction in

the forked shaft (15) of the thread trimmer lever (1) (see

illustration on page 8).

S-7300A

12. STANDARD ADJUSTMENTS

Table of Contents