Brother S-7300A Instruction Manual page 64

6. USING THE OPERATION PANEL (ADVANCED OPERATIONS)
Sewing program settings (400 to 499)
No. Setting range
400 ON/OFF
401 ON/OFF
402 1 - 2
403 300 - 4000
(sti/min)
404 300 - 4000
(sti/min)
405 300 - 4000
(sti/min)
406 300 - 4000
(sti/min)
407 ON/OFF
Standard device settings (500 to 599)
No. Setting range
500 OFF, 1 - 3
53
Initial
Setting
value
units
OFF － Stopping during start backtacking and sewing speed
ON: When the treadle is returned to the neutral position, start backtacking
OFF: When the treadle is returned to the neutral position, start backtacking
ON －
Feed direction when sewing machine motor is stopped immediately after
start backtacking is complete
OFF: Sewing machine motor stops after start backtacking is
* If MSW-400 is set to "OFF", operation occurs when the treadle
is depressed slightly.
ON: After start backtack sewing, the feed moves forward, then
1 Fixed stitch sewing load FUNC when stitch control in reverse direction.
1
1: Reverse stitch sewing when hand switch is ON
2: Fixed stitch sewing when hand switch is ON
4000
100 1st stitch sewing speed for slow start original pattern
4000
100 2nd stitch sewing speed for slow start original pattern
4000
100 3rd stitch sewing speed for slow start original pattern
4000
100 4th stitch sewing speed for slow start original pattern
OFF － Synchronize with main pitch of backtack sewing pitch
ON: Synchronized
OFF: Not synchronized
Initial
Setting
value
units
1
1 Presser foot lifter SW function
OFF: Disabled
1: Presser foot lifter switch
2: Puller switch (alternate)
3: Puller switch (momentary)
* Puller operation is enabled when MSW-960 is set to "1" (it does not
operate when set to other than "2" or "3").
(Refer to the Service Manual for details on MSW-960.)
* If set to puller switch, the presser foot lifting function using the switch is
disabled.
Setting details
can be stopped before it is finished, and the speed during start
backtacking becomes the speed corresponding to the treadle
depression amount (low speed - start backtacking speed)
ends, sewing stops and the sewing speed becomes the start
backtacking speed (constant)
complete
the sewing machine motor stops.
Setting details
S-7300A