Table of Contents
Advertisement
prompts an error tone, and the power level will not change.
* If you switch to low power on a channel that was set with high power, this configuration is
done on all other channels that were set with high power.
BOT ID and EOT ID
Your dealer may configure whether to transmit Connect ID (BOT ID) and Disconnect ID
(EOT ID), when connecting or disconnecting a repeater or telephone system. The
following modes are programmable:
1. BOT ID occurs on each press of [PTT].
EOT ID occurs on each release of [PTT].
2. Press the [*] while holding down the [PTT], then BOT ID is transmitted.
Pres the [#] while holding down the [PTT], then EOT ID is transmitted.
Scan
▇ Scan Type
1. Single Zone Scan
Radio scans all the channels that added into the scan list on the current zone.
2. Multi Zone Scan
Multiple zones that added into a multi scan list can be scanned. All channels within all the
zones that added into the scan list can be scanned.
▇ Scan Start
1.
Add one or several non-priority channels into the scan list.
2.
Press the programmed Channel Scan key to initiate scan from the current channel,
and ascends through the channel numbers in scan list. The LCD displays the "SCAN"
icon ("-SCAN-" indicates multi zone scan).
▇ Scan Cease
Scanning pauses or ceases upon the following:
1. Upon repress the programmed Channel Scan key, scanning ceases, and the radio
第 页 共 32 页
19
Advertisement
Table of Contents
