Step 4 Initializing The Software - Contec DIO-32DM2-PE User Manual

2. Setup

Step 4 Initializing the Software

The driver library requires the initial setting to recognize the execution environment. It is called the
initialization of the Driver library.
This software is initialized automatically during hardware installation. Therefore, if you want to use it
with its initial settings, you can skip the setting procedure described in Step 4. To change the device
name, follow the setting procedure shown below.
Setting the device name
(1) Run Device Manager.
[Device Manager] tab.
(You can also open Device Manager by right clicking on My Computer and selecting Properties.)
CAUTION
When you install this product, the displayed board name is unlike product name.
It is displayed as "DIO-32DM-PE".
(2) The installed hardware appears under the CONTEC Devices node. Open the CONTEC Devices
node and select the device you want to setup (the device name should appear highlighted). Click
[Properties].
20
From [My Computer] - [Control Panel], select [System] and then select the
* The name of the board
you have just added is
displayed.
- DIO-32DM-PE "DIO000"
DIO-32DM2-PE