Setting The Board Id; Setting The Pull-Up - Contec DIO-32DM2-PE User Manual

2. Setup

Setting the Board ID

If you install two or more boards on one personal computer, assign a different ID value to each of the
boards to distinguish them.
The board IDs can be set from 0 - Fh to identify up to sixteen boards.
If only one board is used, the original factory setting (Board ID = 0) should be used.
Setting Procedure
To set the board ID, use the rotary switch on the board. Turn the SW6 knob to set the board ID as
shown below.
SW6
BOARD ID
8
Factory setting:
(Board ID = 0)
Figure 2.2. Board ID Settings (SW6)

Setting the Pull-Up

If the pull-up to input points and control signals is required, please set. In addition, the pull-up voltage
can be selected from the 3.3V and 5V. It should be noted that the present setting in the input 32 points
(16 points each) and control signals can be set individually. If you want to use the input and output
points as output, please use in the state of factory setting (no pull-up).
Setting Procedure
For setting the pull-up in jumper pins (JP1 to JP3) and slide switches (SW1 to SW5) on the board.
Please to see set the figure below.
14
DIO-32DM2-PE