ProLights V575WASH User Manual page 28

12
PAN Offset:
Fine adjustment for the horizontal pan head position
TILT Offset:
Fine adjustment for the vertical pan head position
Focus adjustment. After pressing the button ENTER, the head will go to the vertical position first; after each further
actuation of the button ENTER, the four principal directions in the horizontal will be selected. In the position which
is closest to the intended direction of projection, the focus can be adjusted with the buttons DOWN and UP:
By pressing the button MENU, the adjustment will be confirmed. The adjustment made here will merely help to adjust the
other parameters in this menu; it is insignificant for operation.
Colour wheel offset
Fine adjustment for the filter position of the colour wheel
DIMMER Offset:
Dimmer Fine adjustment
By pressing the button MENU, the adjustment will be confirmed. The adjustment made here will merely help to adjust
the other parameters in this menu; it is insignificant for operation.
3.10 Remote control EC800 (optional)
The remote control EC800 (see fig.2) available as an accessory allows to control different functions:
1. Connect the remote control to the jack REMOTE CONTROL (4).
2. The DMX input (6) must not be connected; the yellow LED MASTER (15) must light up.
3. Via the DMX output (5), it is possible to connect further V575WASH units in order to control them with
the remote control in sync with the master unit.
4. With the button STAND BY, the function blackout can be switched on and off. With the function switched on,
the LED next to the button will light up. The pan head will go to its starting position and the shutter is closed.
5. With the button MODE (18), select the operating mode:
a) Mode SOUND 1 (LED next to the button does not light up).
By keeping the button FUNCTION (19) pressed, one of the three stroboscopic effects can be activated:
- strobe effect with varying colours;
- strobe effect with white light; identical effect for the slave units;
- strobe effect with white light; opposite effect for the slave units.
b) Mode SOUND 2 (LED flashing slowly).
By pressing the button FUNCTION (19), one of the four show operating modes can be activated. When
pressing the button FUNCTION once again, the next show operating mode respectively will be activated.
c) SLOW/SOUND (LED lights continuously).
In this operating mode, only the movement of the light beam is music-controlled. The colours are changed
by the button FUNCTION. When pressing the button FUNCTION shortly, the next colour will be selected;
when pressing it longer, the next pattern will be selected.
d) POSITION (LED flashing rapidly).
First the horizontal position of the head is defined by keeping the button FUNCTION pressed. Then the
vertical position of the head it defined by keeping the button FUNCTION pressed. Finally the value for the
dimmer or a prism effect is adjusted by keeping the button FUNCTION pressed. The positions and dimmer
values are defined for the master first, then the adjustments for the slave units will follow. The range of the
pan head during the modes SOUND 1 and SOUND 3 depends on the operating mode Show 1, Show 2, Show
3, or Show 4 selected in the menu or in the mode SOUND 2 via the remote control and shown on the display.
V575WASH
. . .
. . .
. . .
. . .
. . .