ProLights V575WASH User Manual page 26

10
3.8 Changing the operating parameters
The parameters described below can be changed by calling the menu:
1. Press the button MENU (11) so many times until the corresponding menu item is shown on the display.
2. For the first eight menu items (
button ENTER (13). Then make the adjustment with the button DOWN or UP (12) and memorize it with
the button ENTER within 8 seconds. The operation of the other menu items is described in detail. When
these menu items are selected, the display starts flashing.
3. To go to the next menu item, press the button MENU or select the desired menu item with the buttons
UP and DOWN (12).
4. If no further button is pressed for 8 seconds while a menu item is selected, the menu will disappear.
Adjustment of the start address:
16/8-channels DMX mode:
Show mode:
Slave mode:
Blackout mode:
Pan motion of the pan head:
Tilt motion of the pan head:
LED Display on/off:
After exiting the menu, the address or the operating mode will be displayed for approx. 30 s, then the display is switched
off. As soon as one of the buttons (11 – 13) is pressed, the display will be switched on again.
Display representation:
Switch over the adjustment with the button ENTER. The display will flash for 8 seconds. Then the menu will disappear.
V575WASH
start address to
. . .
16 channels
8 channels
show 1
show 4
. . .
normal
2 light show
. . .
Blackout on (yes blackout). If no DMX control signal is
present at the jack DMX INPUT (6), the pan head will go to its
starting position and the shutter is closed. Operation via the
remote control is possible.
Blackout off (no blackout). If no DMX control signal is present,
the unit is controlled via the integrated microphone and, if
desired, via the remote control.
normal
opposite panning
normal
opposite movement
display on
display off
normal
turned by 180° (for ceiling suspension)
display off ), confirm the selection with the