ProLights V575WASH User Manual page 27

Zoom adjustment. After pressing the button ENTER, the head will go the vertical position first; after each further
actuation of the button ENTER, the four principal directions of the horizontal will be selected. In the position which
is closest to the intended direction of projection, the zoom can be adjusted with the buttons DOWN and UP:
Confirm the adjustment with the button ENTER. The value will be memorized and taken into account for the show
programmes 1– 4.
Self-test. After pressing the button ENTER, a test programme will be executed. To stop it, press the button
MENU. The next menu item will flash for 8 seconds. Then the menu will disappear.
Ambient temperature of the lamp. After pressing the button ENTER, the ambient temperature of the lamp (in
°C) will be indicated.
Working hour meter (fixture hours). After pressing the button ENTER, the display will show the working hours.
To return to the previous operating mode, press the button MENU. The next menu item will flash for 8 seconds.
Then the menu will disappear.
Lamp on/off. After pressing the button ENTER, the lamp can be switched on or off with the button UP or DOWN.
Confirm the selection with the button ENTER.
Note: After switching off, the discharge lamp will not be able to ignite again immediately when it is still hot. Therefore,
there may be a delay of a few minutes before it is switched on again.
Lamp on/off on starting. After pressing the button ENTER, the lamp can be switched on or off with the button
UP or DOWN.
Confirm the selection with the button ENTER.
Note: After switching off, the discharge lamp will not be able to ignite again immediately when it is still hot. Therefore,
there may be a delay of a few minutes before it is switched on again.
Reset. By pressing the button ENTER, the unit is reset: The pan head will shortly go to its starting position and
the shutter is closed. Then the unit will return to its previous operating mode.
3.9 Presetting of corrective values (offset mode)
For fine adjustment of the pan head position, the dimmer, and the colour wheel, readjustments can be
made in this mode.
1. Keep the button MENU (11) pressed for at least 5 seconds. The first menu item will be displayed.
2. Press the button MENU so many times until the desired menu item is displayed.
3. Confirm the selection with the button ENTER (13).
Then make the adjustment with the button DOWN or UP and memorize it with the button ENTER within
8 seconds. For the menu point
sponding paragraph.
4. To go to the next menu item, press the button MENU or select the desired menu item with the buttons
UP and DOWN.
5. If no further button is pressed for 8 seconds while a menu item is selected, the menu will disappear.
Note: when calling this menu, the pan head will always go to the vertical position. If this direction of pro-
jection or the current focus is not suited for the readjustments intended, call the menu item
adjustment) first and select another direction of projection or change the focus. The order shown here cor-
responds to the order of the menu items:
V575WASH
. . .
normal
lamp on
lamp on
(focus adjustment) which is different than the others see the corre-
lamp off
lamp off
11
(focus