Table of Contents
Advertisement
9.
PROGRAMMING PROCEDURES
9.10
SPEED KEY SETTING
Menu Page: 1
Item No.:
9
The H-9000 has a maximum of 70×2 speed keys which are very convenient to call PLUs quickly.
(Refer to page 5-3 regarding the Key Layout.)
<MENU>
Page 1
Setting Department/Vendor Number
■
<MENU>
Page 1
ENTER
Selecting items to be assigned
to speed keys.
(PLU #/VENDOR #/DEPT #/)
Department Number
●
When initial set #10-6 is set to "1", the six-digit PLU # is divided into two; the upper two digits are assigned to department #, and the lower
four digits to PLU.
The department # is automatically added in the front of the four-digit PLU # and treated as a six-digit PLU #.
In case of "PROG.", "Report", and "Reset" modes, PLU # is treated as a six-digit number. So the upper two digits are not treated
as department #. Consequently the four-digit PLU # is available only in "REG.", "M.DOWN", and "REWRAP" modes.
NOTE: The default Dept No. is a two- digit serial number ranging from o to 99. Entering a "0" clears a Dept. No.
Vendor Number
●
Vendor numbers can be be set when the Initial Setting #11-1 is set to 1.
Vendor numbers are assigned to the speed keys in two ways:
① Individual vendor number: 00-39
Vendor # is assigned to the speed keys one by one.
② Group vendor number: 0-, 1-, 2- and 3-
Maximum 10 vendor numbers can be assigned to one speed key, resulting in 4 speed keys in total. When assigning group vendor
numbers to the speed keys, enter the first digit of the vendor key (0, 1, 2 or 3) plus a bar (-).
Vendor numbres can be called whichever half of the speed keys are selected.
i
9
◇
Toggles the speed
key Page
Enter the PLU#.
(max. 6 dig.)
9
AUTO
CODE
Enter the department #
◇
or vendor #. (1∼99)
Enter the Speed
Key number
(# 1∼70 on each page)
NEXT
or
PLU
i
PROG.
ENTER
ESC.
Enter the default
department #. (1∼99)
9- 17
9.10 SPEED KEY SETTING
<MENU>
Page 1
Main
<MENU>
Enter the speed
key number.
ENTER
PROG.
ENTER
ESC.
ENTER
<MENU>
Page 1
Main
<MENU>
Advertisement
Table of Contents
