TEC EO1-32004 Owner's Manual page 44

9. ROGRAMMING PROCEDURES
■ Table 4: Transmission Item List
ITEM #
2 VERIFY PLU & ING. = CMT 2
3 READ PLU & ING. FM CMT 3
4 WRITE PLU TO CMT
5 VERIFY PLU = CMT
6 READ PLU FROM CMT
7 WRITE ING. TO CMT
8 VERIFY ING. = CMT
9 READ ING. FROM CMT
10 WRITE NUTRI. TO CMT
11 VERIFY NUTRI. = CMT
12 READ NUTRI. FM CMT
13 WRITE SPEED KEY
14 VERIFY SPEED KEY
15 READ SPEED KEY
NOTE: When the PL-3 is connected, more than one FDK may be required depending on the
amount of ING. data.
Be careful of the following when changing a FDK.
a: During the write operation, replace with a formatted FDK.
b: Verify and read data in same order as the write.
To cancel to change a FDK, press the
Title on the Display
10
11
12
13
14
15
Contents of Transmission
COMPARE PLU & ING. IN OLD FORMAT
READ PLU & ING. IN OLD FORMAT
4 SAVE PLU IN NEW FORMAT
5 COMPARE PLU IN NEW FORMAT
6 READ PLU IN NEW FORMAT
7 SAVE ING. IN NEW FORMAT
8 COMPARE ING. IN NEW FORMAT
9 READ ING. IN NEW FORMAT
SAVE NUTRITION IN NEW FORMAT
COMPARE NUTRITION IN NEW FORMAT
READ NUTRITION IN NEW FORMAT
SAVE SPEED KEY IN NEW FORMAT
COMPARE SPEED KEY IN NEW FORMAT
READ SPEED KEY IN NEW FORMAT
CLEAR
9- 22
○: operable, ×: inoperable
key.
9.13 CMT/PL-3
CMT PL-3
○ ○
○ ○
○ ○
○ ○
○ ○
× ○
× ○
× ○
○ ○
○ ○
○ ○
○ ○
○ ○
○ ○