Table of Contents
Advertisement
12. OPERATING PROCEDURES
12.6
TARE/SAVE FUNCTION PROCEDURES
NOTE: This operation is available only when the optional scale unit is connected.
Menu: REG., M.DOWN, or REWRAP
Mode: WEIGH or FIX (Tare % function is available in WEIGH mode only.)
There aretwo kinds of tare subtraction procedures, one is "Direct tare", the other is "Preset tare ".
SAVE
The
key is used to save the tare, unit price, and PLU data after taking a commodity from the
platter.
Place a container on
the platter.
(Ex. 0.200 lb)
Press:
Enter the PLU #.
Press:
The PLU data and tare are
saved.
Place a commodity on the
platter.
(Ex. 1.000 lb)
MANUAL:
PRT
Press:
Remove the commodity
together with the container.
NOTES:
1. Tare subtraction is available up to 2.000 lb. When tare subtraction is in operation, however, the scalable range for net
weight becomes less by the amount of the tare. (Net weight-Gross weight-Tare)
2. Preset tare must be a multiple of 0.005 lb.
3. The tare % function is available when the Initial Setting #28-4 is set to 1. The speed key #70 will function as the % key
(Refer to page 5-3). Set a tare % within the range from 0.0 to 99.9.
4. When a commodity is placed on the platter and the calculated tare exceeds the maximum, a "TARE WEIGH OVER"
error will occur.
0.200 lb
T
1
0
0
PLU
SAVE
:AUTO
*
The label is issued.
C
2
0
0
T
Tare %
%
1
0
0
%
12-11
12.6 TARE/SAVE FUNCTION PROCEDURES
1
Press:
Place a container
on the platter
Remove the Commodity
together with the container.
Press:
C
CA type
PLU
Press:
Tare %
0
0
%
US type
0
Press:
T
Press:
PLU
Press:
Advertisement
Table of Contents
