Table of Contents
Advertisement
9.
PROGRAMMING PROCEDURES
9.18
TRANSFERRING LOGO DATA
Menu Page: 2
Item No.:
8
Logo data is created on a PC and stored into RAM through the CMT interface. Two different sizes of
logos, 320x118 dots and 256x64 dots, are available on the H-9000. 64 KB of RAM area is secured for
logo data, in which the maximum of 13 logos (320x118 dots) or 26 logos (256x64 dots) can be stored.
Before starting the following operation, set the initial setting #10-7 to 1.
<MENU>
Page 2
NOTE: Two sizes of logos are printed differently as follows:
Print LOGO
(320 x 118 dots)
Display LOGO
(256 x 64 dots)
: Logo data
: Print/Display area
Load the tape into
8
the CMT Loader
PROG.
ENTER
ESC.
<Display>
64
256
(Part of LOGO is
displayed.)
Select a transmission item.
1: SAVE (H-9000 CMT)
2: VERIFY (H-9000=CMT)
3: LOAD (H-9000 CMT)
<MENU>
Page 2
Main
<MENU>
<Label>
1st LOGO
160
80
2nd LOGO
(Part of LOGO is
printed.)
104
118
64
256
FSP LOGO
(Part of LOGO is
overlapped with
FSP print area.)
1st LOGO
(LOGO is printed on the
center of printing area.)
160
64
2nd LOGO
(Part of LOGO is
printed.)
FSP LOGO
(LOGO is printed on
part of FSP print
area.)
9- 29
9.18 TRANSFERRING LOGO DATA
<Receipt>
(LOGO #1 & half of LOGO
#2 are printed.
Advertisement
Table of Contents
