Table of Contents
Advertisement
Status Indicators
the four top and three bottom UpS status indicators on the main screen and their meanings are listed in
the table below. .
Indicator
96%
Shows the current load percentage.
battery information: in on-line and battery back-up mode the display alternates between
battery charge percentage and estimated remaining battery runtime in:
100% / 11'
minutes for runtimes > 10 min.
100% / 9' 35"
minutes and Seconds for runtimes < 10 min.
100% / n/A
in other modes, the display alternates between battery charge percentage and "n/A."
Shows current UpS Status. indicator will change as the UpS status changes. For a
inV
detailed listing see page 56.
12:35 pm
System time
dVCoH
Fault description Code - For a detailed listing see 53.
ASyn
warning description Code - For a detailed listing see page 54.
on-line
Current operating mode of the UpS - For a detailed listing see page 56.
Light Emitting Diodes (LED)
the following table describes the front panel led behaviors and the associated meaning.
LED
Behavior
green - on
green - oFF
green - oFF
on-line/
red - on
Fault
red - Flashing
red - oFF
Amber - on
Amber - Flashing
warning
Amber - oFF
green - on
green - Flashing
AC input
green - oFF
NOTE: On-Line/Fault LEDs - Appear Orange if Green and Red flash concurrently.
1600Xp Series installation and operation manual
Functional Description
Significance/Meaning
UpS is in on-line, backup, or battery test mode.
UpS in bypass mode.
UpS in shutdown mode.
one or more faults occurred. See Records: Faults for details.
Charger overvoltage occurred.
no fault occurred.
Service Call needed, Less than 6 mo. of Battery Life or Battery Life
End.
one or more warnings occurred. See Records: Warnings for details.
no warning (normal, UpS in operation).
Input and Bypass voltage is within specified range.
Input and Bypass voltage is over specified range.
Input and Bypass voltage is under specified range.
35
Advertisement
Table of Contents
