Fuse Replacement - Accu-Scope EXC-120-PL Manual

ADJUSTMENT & OPERATION
Fig. 18
Fig. 19
Fig. 20
Fig. 21
®
ACCU-SCOPE
Replacing the Fuse - (Fig. 18-22)
Before replacing a fuse, turn the power switch ① to "O"
(Off), and unplug the power cord from the outlet and the
microscope.
The fuse holder is located on the back of the microscope
next to the power cord receptacle.
①
Insert a flat head ( — ) screwdriver into the notch on the
fuse holder. (Fig. 19)
Carefully slide fuse holder up from the fuse socket and
remove the holder (Fig. 20).
Carefully remove a fuse from the fuse holder by tilting out
as shown (Fig. 21) and replace with a new one – also tilting
it as you slide it in – it will click into place.
Reinstall the fuse holder into the fuse socket by sliding it in
until it clicks back into place (Fig. 22).
Plug the power cord into the base of the microscope and
then into a wall outlet.
Turn the power switch to " I " (On).
NOTE: Replace the fuses with 0.5 amp fuses. Using any
other fuse type may result in diminished illumination and
may cause damage to your microscope.
Specification of the fuse: 250V, 0.5A.
CAT # 3277
EXC-120 MICROSCOPE SERIES
(continued)
Fig. 22
14