Setting Marker Display - Sony HDC-750 Operation Manual

4-5 Setup Using the OPERATION Menu

4-5-2 Setting Marker Display

The MARKER page of the OPERATION menu is
used to turn ON or OFF the display of the center
marker, safety zone marker, 4:3 frame marker, 4:3
modulation marker, and effective pixel area. It is also
used to set display areas and display positions.
To set up marker display
VF DISP switch
MENU SEL control
1
Set the VF DISP switch to MENU.
2
Rotate the MENU SEL control to display the
MARKER page, and push the MENU SEL control.
CENTER: Set to ON to display the center marker
CENTER SEL: Selects the type of center marker
(1 to 4)
SAFETY ZONE: Set to ON to display the safety
zone marker
SAFETY AREA: Selects the safety zone area
(80%, 90%, 92.5%, or 95%)
4:3 FRAME: Set to ON to display the 4:3 frame
marker
4:3 MODULATION: Set to ON to display the 4:3
modulation
4:3 MODU LEVEL: Selects the 4:3 modulation
level (0 to 100%)
EFFECTIVE AREA: Set to ON to display the
effective pixel area
3
Rotate the MENU SEL control to align the "n"
marker with the item to be changed, and push the
MENU SEL control.
The "n" marker will change into a "?" mark.
4-12(E)
Chapter 4 Adjustments and Settings for Recording
4
Rotate the MENU SEL control to change the
setting to the desired value, and push the MENU
SEL control.
The "?" mark will change back to the "n" marker
and the new setting will be saved.
5
To end menu operations, set the VF DISP switch to
ON.
4-5-3 Setting Gain Values for the
GAIN Switch Positions
You can set video amplifier gain values to be selected
by the three positions (L, M, and H) of the GAIN
switch. Use the GAIN SW page of the OPERATION
menu to make these settings.
To set gain values for the GAIN switch
positions
VF DISP switch
MENU SEL control
1
Set the VF DISP switch to MENU.
2
Rotate the MENU SEL control to display the
GAIN SW page, and push the MENU SEL control.
LOW: Sets the gain value selected when the
GAIN switch is set to L
MIDDLE: Sets the gain value selected when the
GAIN switch is set to M
HIGH: Sets the gain value selected when the
GAIN switch is set to H
3
Rotate the MENU SEL control to align the "n"
marker with the item to be changed, and push the
MENU SEL control.
The "n" marker will change into a "?" mark.